Table of Contents
Advertisement
4.
Start the CLI.
[vrf:none] root@re0:~# cli
5.
Enter configuration mode.
root@re0> configure
6.
Stop the chassis auto-upgrade process.
[edit]
root@re0# delete chassis auto-image-upgrade
7.
Stop zero-touch provisioning (ZTP).
[edit]
root@re0# delete system commit factory-settings
NOTE: ZTP is enabled on the ACX7100-48L in the factory-default configuration. You must stop ZTP before
you configure any settings. Until you assign a root password and make an initial commit, you might see ZTP-
related messages on the console. You can safely ignore these messages while you configure the root
password.
8.
Add a password for the root administration user account.
[edit]
root@re0# set system root-authentication plain-text-password
password
New password:
Retype new password:
9.
Commit the configuration, and wait for the ZTP process to stop.
[edit]
root@re0# commit
A message appears on the console, confirming that the ZTP process has stopped.
root@re0# [ 968.635769] ztp.py[20083]: 2021-06-09 16:47:52 INFO: ZTP: aborted in state
DISCOVERING_INTERFACES
password
8
Advertisement
Table of Contents
