Table of Contents
Advertisement
PAPER HANDLING
Button/Dial
(LED)
FRONT
DIR/AUTO
GAP
(LCD)
FRONT
DIR/GAP
ADJUST
(LED)
AUTO GAP
(LED)
MANUAL
GAP DIAL
(LCD)
GAP
ADJUST
3-4
User's Manual
Table 3.1 Buttons Used for Paper Handling (Cont.)
Purpose
Select cut
sheet ejection
MICRO
Micro Feed
MICRO
Select paper
thickness
control mode
Select paper
Thickness at
MANUAL
MODE
Select paper
Thickness
Action
(LED)
Press FRONT DIR/AUTO GAP at Offline to select
a direction of ejecting cut sheet.
(LCD)
Press FRONT DIR/ GAP ADJUST at Offline to
select a direction of ejecting cut sheet.
• Front ejection – FRONT indicator lights. It
blinks when paper is ejected to
the paper table prompting the
user to remove the paper.
• Rear ejection –
FRONT indicator does not
light.
When you save your setting in the setup mode, it
becomes the new default. The default setting is
invoked whenever you turn on the printer.
Press
MICRO/
MICRO to feed paper by
1/180 inch in the direction of the arrow.
Select paper thickness control mode.
AUTO GAP — AUTO GAP indicator lights.
Manual Gap — AUTO GAP indicator doesn't
lights.
The Manual Gap dial is enabled.
Select the paper thickness at MANUAL MODE.
Auto Gap is usually used. Auto Gap is used for
printing on paper of different thicknesses.
Select the paper thickness as follows.
AUTO,GAP-1,･･･････,GAP-9,GAP-A,･･,GAP-D
PAPER HANDLING
User's Manual
3-4
Advertisement
Table of Contents
