Fujitsu Impact 4550 PRO User Manual page 144

USING SETUP MODE
5-42 User's Manual
Table 5.6 ADJUST Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
ADJUST Options
Items
<FCNTBTM>
-30/180, ..., 0/180,
..., 30/180
<RCNTBTM>
-30/180, ..., 0/180,
..., 30/180
<CUT-BTM> -30/180, ..., 0/180,
..., 30/180
USING SETUP MODE
Description
It is possible to fine-tune the bottom
blank by every 1/180 inches for its
amount (4.2mm) of the front
continuous form.
NOTE:
This setting is effective only at <
FCNT-PE:EDGE >.
It is possible to fine-tune the bottom
blank by every 1/180 inches for its
amount (4.2mm) of the back
continuous form.
NOTE:
This setting is effective only at <
FCNT-PE:EDGE >.
It is possible to fine-tune the bottom
blank by every 1/180 inches for its
amount (4.2mm) of the cut sheet paper.
User's Manual 5-42