Onkyo TX-RZ70 Instruction Manual page 142

3. Audio Adjust 3. Audio Adjust
„ 1. Multiplex/Mono
Change the settings of multiplex audio playback.
‰ Multiplex Input Channel (Default Value: Main)
Set the audio channel or language to be output when playing multiplex audio or
multilingual broadcasts, etc.
• For multiplex audio broadcasts, pressing the
controller will display "1+1" on the main unit's display.
Main Main channel only
Sub Sub channel only
Main / Sub Main and sub channels will be output at the same time.
‰ Mono Input Channel (Default Value: Left + Right)
Set the input channel when playing back analog or 2 ch PCM signals in the
Mono listening mode.
Left Left channel only
Right Right channel only
Left + Right Left and right channels
‰ Mono Output Speaker (Default Value: Center)
Set the speaker to output monaural audio in the Mono listening mode.
• If an item cannot be selected even though connection is correct, check that
the settings in "Speaker" - "Configuration" - "Speaker Channels" matches the
number of connected channels.
Center Audio is output from the center speaker.
Left / Right Audio is output from the front L/R speakers.
button on the remote
„ 2. Dolby
Change the setting of when Dolby signals are input.
‰ Loudness Management (Default Value: On)
When playing Dolby TrueHD, enable the dialog normalization function which
keeps the volume of dialog at a certain level. Note that when this setting is Off,
the Late Night function that allows you to enjoy surround at low volumes is fixed
to off when playing Dolby Digital Plus/Dolby TrueHD.
On When this function is used
Off
When this function is not used
‰ Center Spread (Default Value: Off)
Adjust the width of the front sound field created when playing back with the
Dolby Audio - Surr listening mode.
• Depending on the speaker settings, "Off" is applied.
The sound field is spread to left and right.
On
Off The sound field is centralized.
Setup Setup
142