Table of Contents
Advertisement
2. Speaker
‰ Speaker Impedance (Default Value: 6 ohms or above)
Set the impedance (Ω) of the connected speakers.
• For impedance, check the indications on the back of the speakers or their
instruction manual.
When any of the connected speakers have 4 Ω or more to less
4ohms
than 6 Ω impedance
6 ohms or above When all the connected speakers have an impedance of 6 Ω
or more
„ 2. Crossover
Set what number of Hz in the low frequency range is output from each speaker
and what should be output from the subwoofer. When a subwoofer is not to be
used, set to "Full Band" so that the bass is output from the speakers.
• When Dirac Live Bass Control ( →p170) is used, the crossover frequency
setting made here is not available. Set using Onkyo Controller ( →p169).
‰ Dirac Live Bass Control (Default Value: Off)
Use the Dirac Live Bass Control to adjust the crossover frequency.
On
When using Dirac Live Bass Control. This can be selected
when Dirac Live Bass Control measurements are performed.
Off
When this function is to not be used
‰ Crossover Type (Default Value: Normal)
Set the crossover frequency to suit the speakers.
Klipsch
When Klipsch speakers are used. The crossover that is
optimum for the speakers selected in Speaker Combo
( →p141) is applied. In this case, the crossover for each
speaker cannot be changed.
Normal
When other than Klipsch speakers are used
Front
(Default Value: 80 Hz (THX))
Center
(Default Value: 80 Hz (THX))
Height 1
(Default Value: 80 Hz (THX))
Height 2
(Default Value: 80 Hz (THX))
Surround
(Default Value: 80 Hz (THX))
Surround Back
(Default Value: 80 Hz (THX))
LPF of LFE
(Default Value: 120 Hz)
Double Bass
(Default Value: On)
• As for the THX-certified speakers, the following settings are recommended.
– Crossover frequency → "80 Hz(THX)"
– "LPF of LFE" → "80 Hz"
– "Double Bass" → "Off"
• This setting is disabled when the IMAX sound mode has been applied.
Setup
Setup
135
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
