Onkyo TX-RZ70 Instruction Manual page 109

Selecting a source to play in ZONE 2
1. While pressing the ZONE 2 HOLD button on the remote controller, press the
input selector of the input you want to play in the separate room.
To control on the main unit, press the ZONE 2 button on the main unit and
then within 8 seconds press the input selector button of the input you want to
play in the separate room.
1
• Information of a connected device can be displayed on the TV screen in the
separate room. While pressing and holding the ZONE 2 HOLD button on the
remote controller, press the " " button.
Adjusting the volume in ZONE 2
When ZONE 2 speakers are used
1. While pressing the ZONE 2 HOLD button on the remote controller, adjust with
the volume buttons. To control on the main unit, press the ZONE 2 button on
the main unit and then within 8 seconds adjust with the MASTER VOLUME
dial.
2
When using an Integrated amplifier in the separate room
1. Use the volume dial on the integrated amplifier to adjust the volume.
When using an integrated amplifier that does not have a volume control,
adjust using the same procedure described in "When ZONE 2 speakers are
used".
• When connecting an integrated amplifier that does not have a volume
control, in the Setup menu, set "Multi Zone" - "Zone 2" - "Output Level"
( →p158) to "Variable". If you do not set this, the volume output will be
very loud and there is a danger of damage to the integrated amplifier,
speakers, etc.
• You can also adjust the sound quality of a power amplifier connected in a
separate room. After pressing the ZONE 2 button on the main unit, within 8
seconds press the TONE button, and adjust by pressing the - and + buttons.
Playback
2
1
109