Appendix; Configuring The Switch With The Cli-Based Setup Program; Accessing The Cli; Accessing The Cli Through Express Setup - Cisco Catalyst 2350 Installation Manual

Configuring the Switch with the CLI-Based
Setup Program
This appendix provides a CLI-based setup procedure for a Catalyst 2350 switch. Before connecting the
switch to a power source, review the safety warnings in

Accessing the CLI

For an unconfigured switch, you can access the CLI through Express Setup or through the console port.

Accessing the CLI Through Express Setup

You can access the CLI on an unconfigured switch by placing the switch in Express Setup mode and then
connecting a switch Ethernet port or the Ethernet management port to the Ethernet port of your PC or
workstation. To put the switch into Express Setup mode, follow the steps described in the getting started
guide for powering on the switch and using Express Setup.
When the switch is in Express Setup mode, open a Telnet session to the switch by entering the IP address
10.0.0.1. Enter the setup user EXEC command. Enter the information described in the
Initial Configuration Information" section on page
After you have entered the configuration information for the switch, save it to flash memory by using
the write memory privileged EXEC command.
While in Express Setup mode, the IP address 10.0.0.1 remains active on the switch until you enter the
Note
write memory command. You lose the Telnet connection after entering the write memory command.
For more information about using the CLI, see the command reference for this release.

Accessing the CLI Through the Console Port

You can access the CLI on a configured or unconfigured switch by connecting the console port of the
switch to your PC or workstation and accessing the switch through a terminal emulation program.
OL18479-01
A P P E N D I X
Chapter 2, "Switch Installation."
C-2.
Catalyst 2350 Switch Hardware Installation Guide
C
"Entering the
C-1