Configuring The Switch With The Cli Setup Program; Accessing The Cli Through Express Setup; Required Equipment - Cisco IE 4010 Hardware Installation Manual

Configuring the Switch with the CLI Setup
Program
This appendix provides a command-line interface (CLI) setup procedure for a standalone switch. Before connecting the
switch to a power source, review the safety warnings in

Accessing the CLI Through Express Setup

When you first set up the switch, you should use Express Setup to enter the initial IP information. This process enables
the switch to connect to local routers and the Internet. You can then access the switch through the IP address for
additional configuration.

Required Equipment

You need this equipment to set up the switch:

Computer with Windows 2000/Vista/2003/XP/Window7/Mac.

A Web browser (IE, Firefox) with JavaScript enabled.

A straight-through or crossover Category 5 Ethernet cable to connect your computer to the switch port.
Do not use the RS232 serial console port for express setup.

A small paper clip to reach to button.
Note: Before running Express Setup, disable any pop-up blockers or proxy settings on your browser and any wireless
client running on your computer.
Express Setup Procedure
To run Express Setup:
1. Make sure that nothing is connected to the switch.
2. Ensure the switch is in default factory mode.
Skip to next step if freshly out of the box.
a. If not freshly out of the package, use a paper clip to reset the switch for 10 seconds until the SYS LED light turns
red; then release the paper clip.
Switch will automatically reboot once the SYS led goes red.
3. Ensure no data port is connected to the switch.
Note: During Express Setup, the switch acts as a DHCP server.
Warnings, page 13
Cisco Systems, Inc. www.cisco.com
57
and Installation Guidelines, page 35