Cisco IE 4010 Hardware Installation Manual page 75

Configuring the Switch with the CLI Setup Program
Step 16 You can now manage the switch by using the Device Manager. See
about configuring and managing the switch.
You can display Device Manager by following these steps:
a) Start a web browser on your computer.
b) Enter the switch IP address, username, and password in the web browser, and press Enter. The Device Manager
page appears.
Troubleshooting:
If the Device Manager page does not appear:
• Confirm that the port LED for the switch port connected to your network is green.
• Confirm that the computer that you are using to access the switch has network connectivity by connecting it to a
well known web server in your network. If there is no network connection, troubleshoot the network settings on
the computer.
• Make sure that the switch IP address in the browser is correct.
• If the switch IP address in the browser is correct, the switch port LED is green, and the computer has network
connectivity, continue troubleshooting by reconnecting the computer to the switch. Configure a static IP address
on the computer that is in the same subnet as the switch IP address.
When the LED on the switch port connected to the computer is green, reenter the switch IP address in a web browser
to display the Device Manager. When Device Manager appears, you can continue with the switch configuration.
Management Options, on page 13
Cisco IE 4010 Switch Hardware Installation Guide
Express Setup Procedure
for information
69