Table of Contents
Advertisement
Storage
NOTICE
Failure to store sprayer with Pump Armor
will result in operational problems the next
time you spray. Always circulate Pump
Armor through the sprayer after cleaning.
Water left in the sprayer will corrode and
damage the pump.
Pump Armor fluid protects the sprayer while
in storage. It helps protect sprayer against
freezing and corrosion when not in use.
1.
Clean the sprayer and cup assembly.
See Cleanup, page 17.
2.
Turn Prime Pump/Spray knob down to
the Prime Pump position. Remove cup
support and FlexLiner. Make certain that
VacuValve cap is closed.
ti23285a
3.
Separate the cup support with FlexLiner
from the cup cover/sprayer. Set the
sprayer upside down on a flat surface.
4.
Remove strainer from pump opening.
5.
With the sprayer upside-down pour
approximately 2 oz. (60 ml) Pump Armor
into pump opening.
6.
Install strainer into pump opening.
334179G
Prime Pump
7.
With sprayer upside-down attach cup
support with FlexLiner to sprayer.
8.
Holding sprayer upside-down over a
waste container, pull sprayer trigger for
three seconds.
9.
Turn Prime Pump/Spray knob forward to
spray position. Remove cup assembly
and pour any remaining Pump Armour
back into Pump Armor bottle. Replace
child-resistant cap and tighten securely
for storage.
10. Store sprayer indoors in a cool, dry
place. Store in an upright position only.
Never store sprayer with material in the
cup.
Storage
ti23707b
ti23388a
21
Advertisement
Table of Contents
