Graco TrueCoat 360 Project Series Owner's Manual page 12

Start Up
ti23354a
9. Turn Prime Pump/Spray knob forward to
spray position.
10. Make certain spray tip is in the spray
position.
SPRAY
11. You are now ready to spray.
NOTE: For best results; to evacuate all
material from the FlexLiner when the material
is nearly gone, gently squeeze the bottom of
the FlexLiner to push the last of the material
up to the cup lid.
12
Spray
ti23288a
UNCLOG
ti23290a
If sprayer does not spray, try one of
the steps below:
•
Make certain there is only one FlexLiner
in cup support. It is possible for two liners
to nest tightly together and appear as
only one.
•
Make certain the cup cover is properly
threaded to the cup support. If threads
are visible below the cup cover when
tight, then the cover is cross-threaded.
Fully remove the cup cover and reinstall
to the cup support so no threads are
visible when tight.
ti24454a
•
Repeat steps 2 – 6 on pages 10 – 11 to
ensure all the air is evacuated from the
FlexLiner.
•
Make certain the Prime Pump/Spray
knob is in the Spray position.
•
If sprayer still does not spray, perform
steps 10 and 11 on page 25. If material
sprays while upside down there is air in
the cup. Repeat steps above.
•
Replace VacuValve cap. Extra
VacuValve caps came with your sprayer.
Spray
ti23288a
334179G