Optional Parts Installations; Cutter Installation - Argox X-2300 Series Technical Manual

Hide thumbs Also See for X-2300 Series:

Table of Contents

X-2300/X-3200 Series Technical Manual

7. OPTIONAL PARTS INSTALLATIONS

The printer electronics are susceptible to static discharge.

Wear an anti-static wrist and attach it to the printer chassis

Rotary cutter installation

1. Turn off the power switch.

2. Remove the top covers on both left and right sides.

3. Mount the Cutter baby board to JP15 on Main Board. (Take care of the

location and direction).

4. Secure two screws (3) to fix cutter (1) on bracket (2) (Figure 7.1).

5. Remove the tear-off bracket (5) by releasing screws (4). (Figure 7.2).

6. Insert the left side of cutter bracket (7) and secure two screws (6) to the TPH

module (Figure 7.3).

7. Thread the cutter cable (8) through a hole (Refer to the arrow of Figure 7.3)

and route it to JP14 connector (CUTTER) on the Main Board.

8. Turn on the power switch and enable cutter from panel setting.

Argox Information Co., Ltd.

CAUTION

Figure 7.1

Rev. 1.05

2013/06/11

Table of Contents

X-3200 series