Heat/Cool Digital Outputs - TCS SuperSTAT SZ1053 Configuration Manual

Configuration
STEP 11 Occupied Cool Setpoint D: Set the cooling setpoint for this
occupied period.
STEP 12 Unoccupied Cool Setpoint: Set the Unoccupied Mode's
cooling setpoint.
STEP 13 User Setpoint Limit: Enter the amount a user is allowed the
to adjust the preset occupied setpoints
STEP 14 Override Time: The number of minutes (0 – 255) the
SuperSTAT will maintain overridden occupied setpoints.

Heat/Cool Digital Outputs

STEP 1 Stage Output: Select whether stages 1 and 2 perform heating
or cooling, or whether both are disabled.
STEP 2 Stage 1 Offset: Enter a stage 1 offset value (normally 0).
NOTE: This screen will only display if Stage Output (Step 1)
is enabled.
STEP 3 Stage 2 Differential: Enter a stage 1 differential value.
NOTE: This screen will only display if Stage Output (Step 1)
is enabled.
STEP 4 Stage 2 Offset: Enter a stage 2 offset value (normally 0).
NOTE: This screen will only display if Stage Output (Step 1)
is enabled.
STEP 5 Stage 2 Differential: Enter a stage 2 differential value.
NOTE: This screen will only display if Stage Output (Step 1)
is enabled.
STEP 6 Control Mode: Select whether to control both Stage Outputs
by temperature only (P) or whether to add a time factor (P+I).
7 7
2800 Laura Lane • Middleton, WI 53562
OCCUPIED COOL
SETPOINT D:
UNOCCUPIED COOL
SETPOINT:
LIMIT SETPOINT
ADJUST +/-
SET OVERRIDE
TIME
STAGE OUTPUT 1&2
AS:
STAGE 1
OFFSET:
STAGE 1
DIFF:
STAGE 2
OFFSET:
STAGE 2
DIFF:
SET CONTROL
MODE:
| 800.288.9383 | www.tcsbasys.com
75F
80F
05F
180 MINUTES
COOL
00F
01F
00F
01F
P