Factory Default; Reboot Switch - Planet GS-4210-24T4S User Manual

4.8.1.2 Factory Default

You can reset the configuration default of the switch on this page. Only the IP configuration is retained. The new configuration is
available immediately, which means that no restart is necessary. The Factory Default screen in
to reset the configuration to Factory Defaults.
After the "Restore" button is pressed and rebooted, the system will load the default IP settings as follows:
。
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
。
The other setting value is back to disable or none.
To reset the Managed Switch to the Factory default setting, you can also press the hardware reset button
at the front panel about 10 seconds. After the device be rebooted. You can login the management WEB
interface within the same subnet of 192.168.0.xx.

4.8.1.3 Reboot Switch

The Reboot page enables the device to be rebooted from a remote location. Once the Reboot button is pressed, user has to
re-login the Web interface for about 60 seconds. The Reboot Switch screen in
system.
Figure 4-8-2: Factory Default Page Screenshot
Figure 4-8-3: Reboot Switch Page Screenshot
350
User's Manual of GS-4210 Series
Figure 4-8-2
Figure 4-8-3 appears and clicks to reboot the
appears and clicks