Table of Contents
Advertisement
• Control Vlan
• Revertive
• Guard Time
• WTR Time
• Holdoff Time
Buttons
: Click to refresh the page immediately.
: Click to save changes.
:
Click to undo any changes made locally and revert to previously saved values.
Figure 4-6-3: Ethernet Ring Protocol Switch Configuration page screenshot
VLAN configuration of the Protection Group.
ERPS Protocol Version - v1 or v2
Guard timeout value to be used to prevent ring nodes from receiving outdated
R-APS messages.
The period of the guard timer can be configured in 10 ms steps between 10 ms
and 2 seconds, with a default value of 500 ms
Remaining WTR timeout in milliseconds.
The timing value to be used to make persistent check on Signal Fail before
switching.
The range of the hold off timer is 0 to 10 seconds in steps of 100 ms
: Click to add a new Protection group entry.
User's Manual of GS-4210 Series
335
Advertisement
Table of Contents
