Table of Contents
Advertisement
The page includes the following fields:
Object
• Server Definition
• Server IP
• Authentication Port
• Acct Port
• Key String
• Timeout for Reply
• Retries
Figure 4-5-18: New Radius Server Page Screenshot
Description
Set the server definition.
Address of the Radius server IP/name.
The UDP port to use on the RADIUS Authentication Server. If the port is set to 0
(zero), the default port (1812) is used on the RADIUS Authentication Server.
The UDP port to use on the RADIUS Accounting Server. If the port is set to 0
(zero), the default port (1813) is used on the RADIUS Accounting Server.
The shared key - shared between the RADIUS Authentication Server and the
switch.
The Timeout, which can be set to a number between 1 and 30 seconds, is the
maximum time to wait for a reply from a server.
If the server does not reply within this timeframe, we will consider it to be dead
and continue with the next enabled server (if any).
RADIUS servers are using the UDP protocol, which is unreliable by design. In
order to cope with lost frames, the timeout interval is divided into 3 subintervals of
equal length. If a reply is not received within the subinterval, the request is
transmitted again. This algorithm causes the RADIUS server to be queried up to
3 times before it is considered to be dead.
Timeout is the number of seconds, in the range 1 to 10, to wait for a reply from a
RADIUS server before retransmitting the request.
269
User's Manual of GS-4210 Series
Advertisement
Table of Contents
