Delta A1500 Series User Manual page 48

User Manual
A1500
AC Power Source
PULSE mode lets user insert fixed period, programmed special waveform to output
waveform set at main manual.
Parameter
Count
Vac
F
Period
Duty
Degree On
Select Go to Trigger Mode, press
below at trigger page：
"Trigger On" represents that the trigger is ready. "Stop" is the current output state.
Press
Enter
as shown below. When the user stop the PULSE wave output or the AC power supply
finishes executing the all times of Count, the screen will display "Stop".
45 │ www.deltaww.com
definition
How many times to output programmed Pulse waveform.
If setting is 0, Pulse waveform will output endless
until pressed
Enter
Voltage of Pulse: (high voltage range)
: (low voltage range)
Frequency of Pulse
Duration of total period
Duration time of Pulse, its value can not be greater than
the Period.
Start phase angle of Pulse output
key to trigger. And then the screen will display "Trigger OFF" and "Running"
to do the setting. Screen shows information as
Enter
Range
Min Max
0 10000
0.0 300.0
0.0 150.0
30.0 1000.0
2 60000
1 59999
0.0 359.9