Planet Networking & Communication WGS-4215-8P2S User Manual page 29

To install the 3-pin Terminal Block Connector on the Wall-mount Managed Switch, follow the following steps:
Step 1: Insert positive DC power wire into V+, negative DC power wire into V-, and grounding wire into Ground.
Step 2: Tighten the wire-clamp screws for preventing the wires from loosening.
In some areas, installing a surge suppression device may also help to protect your Managed Switch
Power Notice:
from being damaged by unregulated surge or current to the Managed Switch.
■ Reset Button
On the left of the front panel, the reset button is designed to reboot the Managed Switch without turning off and on the
power. The following is the summary table of reset button functions:
Reset Button Pressed and Released
< 5 sec: System Reboot
> 5 sec: Factory Default
User's Manual of WGS Managed Series
Function
Reboot the Managed Switch.
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings shown below:
Default username: admin
。
Default password: admin
。
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default gateway: 192.168.0.254
。
29