Planet Networking & Communication WGS-4215-8P2S User Manual page 148

below)
Priority
Hello Time
Maximum Age Timer
Forward Delay Timer
The following are the user-configurable STP parameters for the port or port group level:
Variable
Port Priority
Port Cost
Default Spanning-Tree Configuration
User-Changeable STA Parameters
The Switch's factory default setting should cover the majority of installations. However, it is advisable to keep the default
settings as set at the factory; unless, it is absolutely necessary. The user changeable parameters in the Switch are as follows:
Priority – A Priority for the switch can be set from 0 to 65535. 0 is equal to the highest Priority.
a 16-bit priority and a 48-bit Ethernet MAC
address 32768 + MAC
A relative priority for each switch – lower
numbers give a higher priority and a greater
chance of a given switch being elected as
the root bridge
The length of time between broadcasts of
the hello message by the switch
Measures the age of a received BPDU for a
port and ensures that the BPDU is discarded
when its age exceeds the value of the
maximum age timer.
The amount time spent by a port in the
learning and listening states waiting for a
BPDU that may return the port to the
blocking state.
Description
A relative priority for each
port –lower numbers give a higher priority
and a greater chance of a given port being
elected as the root port
A value used by STP to evaluate paths –
STP calculates path costs and selects the
path with the minimum cost as the active
path
Feature
Enable state
Port priority
Port cost
Bridge Priority
User's Manual of WGS Managed Series
Default Value
128
200,000-100Mbps Fast Ethernet ports
20,000-1000Mbps Gigabit Ethernet
ports
0 - Auto
Default Value
STP disabled for all ports
128
0
32,768
148
32768
2 seconds
20 seconds
15 seconds