Planet Networking & Communication WGS-4215-8P2S User Manual page 284

 Type of Service
 ICMP
 ICMP Code

Don't Care: Any value is allowed ("don't-care").
SYN Specify the TCP "Synchronize sequence numbers" (SYN) value for this
ACE.

Set: TCP frames where the SYN field is set must be able to match
this entry.

Unset: TCP frames where the SYN field is set must not be able to
match this entry.

Don't Care: Any value is allowed ("don't-care").
FIN Specify the TCP "No more data from sender" (FIN) value for this ACE.

Set: TCP frames where the FIN field is set must be able to match
this entry.

Unset: TCP frames where the FIN field is set must not be able to
match this entry.

Don't Care: Any value is allowed ("don't-care").
Specify the type of service for this ACE.

Any: No specific type of service is specified (destination port status is
"don't-care").

DSCP: If you want to filter a specific DSCP with this ACE, you can enter a
specific DSCP value. A field for entering a DSCP value appears. The allowed
range is 0 to 63. A frame that hits this ACE matches this DSCP value.

IP Precedence: If you want to filter a specific IP precedence with this ACE,
you can enter a specific IP precedence value. A field for entering an IP
precedence value appears. The allowed range is 0 to 7. A frame that hits this
ACE matches this IP precedence value.
Specify the ICMP for this ACE.

Any: No specific ICMP is specified (destination port status is "don't-care").

List: If you want to filter a specific list with this ACE, you can select a specific
list value.

Protocol ID: If you want to filter a specific protocol ID filter with this ACE, you
can enter a specific protocol ID value. A field for entering a protocol ID value
appears. The allowed range is 0 to 255. A frame that hits this ACE matches
this protocol ID value.
Specify the ICMP code filter for this ACE.

Any: No ICMP code filter is specified (ICMP code filter status is
"don't-care").

User Defined: If you want to filter a specific ICMP code filter with this
ACE, you can enter a specific ICMP code value. A field for entering an
ICMP code value appears. The allowed range is 0 to 255. A frame that
hits this ACE matches this ICMP code value.
284
User's Manual of WGS Managed Series