BenQ SX920+ User Manual page 60

Standby Settings
Network Settings
Reset All Settings
Information menu
This menu shows you the current operating status of the projector.
Some picture adjustments are available only when certain input sources are in use. Unavailable adjustments
are not shown on the screen.
Function
Source
Picture Mode
Lamp Mode
Resolution
3D Format
Color System
Lamp Usage Time
Projector ID
Firmware Version
60 Using the projector
Network
Selecting On enables the function. The projector is able to provide the
network function when it is in standby mode.
Monitor Out
Selecting On enables the function. The projector can output a VGA signal
when it is in standby mode and the PC jack is correctly connected to devices.
See "Connecting a monitor" on page 22
Audio Pass Through
Press / to choose the source that you wish to use in operation mode. See
"Connecting to video equipment" on page 19
When corresponding jacks are correctly connected to the device, the
projector can output an audio signal to the external speaker when it is in
standby mode. The built-in speaker(s) will be muted in standby mode.
Enabling this function slightly increases the standby power
consumption.
Wired LAN
See "Controlling the projector through a Wired LAN environment" on page 43
for details.
Returns all settings to the factory preset values.
The following settings will still remain: names of user modes, 2D
Keystone, Digital Shrink, Language, Projector Installation, High
Altitude, and Password.
Shows the current signal source.
Shows the selected mode in the Picture > Picture Mode menu.
Shows the selected lamp mode in the System Setup: Advanced >
Mode
menu.
Shows the native resolution of the input signal.
Shows the current 3D mode. Only available when 3D mode is enabled
Shows input system format.
Shows the total lamp time used.
Shows projector ID of the projector.
Shows the current firmware version
for how to make the connection.
for how to make the connection.
Description
Lamp