Using The Projector; Turning The Projector On - BenQ SX920+ User Manual

Using the projector

Preparations
1. Plug in and turn all of the connected equipment on.
2. If not already in, plug the supplied power cable into the AC inlet
on the rear of the projector.
3. Plug the power cable into a wall power outlet and turn the wall
switch on.
Please use the original accessories (e.g. power cable) only with the
device to avoid possible dangers such as electric shock and fire.

Turning the projector on

Follow the steps below
1. Make sure the Power light is orange after power has been applied.
2. Press POWER on the projector or ON on the remote control
to start the projector. As soon as the lamp lights up, a "Power
On Tone" will be heard.
To turn off the ring tone, see
Tone" on page 40
3. The fans will start operating, and a start-up image will be displayed
on the screen for a few seconds while it warms up.
The projector will not respond to further commands while it is warming up.
4. If you are prompted for a password, press the arrow keys to enter a six-digit password. See
the password function" on page 26
5. Press SOURCE to select your desired signal. See
6. If the horizontal frequency of the input source exceeds the range of the projector, the message "No
Signal" will be displayed on the screen. This message will remain on-screen until you change the input
source to an appropriate one.
If you attempt to re-start the projector shortly after shutdown, the fans may run for a few minutes to cool
down. Press
I
I
turns orange.
"Turning off the Power On/Off Ring
for details.
for details.
Power again to start the projector after the fans stop and the Power indicator light
"Selecting an input source" on page 24
"Utilizing
for details.
Using the projector 23