Cleaning The Bobbin Case - Brother 884-T11 Operation Manual

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
3 Use the included cleaning brush to remove
any lint and dust from the moving knife, the
fixed knife, the thread retaining plate, and
their surrounding areas.
1 Remove all lint in this area
4 After cleaning is finished, attach the needle
plate in the opposite way that it was
2
removed in step
1 Needle plate
284
.

Cleaning the bobbin case

Thread wax and dust easily collect around the hole
in the tension-adjusting spring on the bobbin case,
resulting in an incorrect thread tension. Therefore,
it should be cleaned each time when the bobbin is
changed.
Use a piece of paper with the thickness of a
business card.
1 Open the hook cover, remove the bobbin
case, and then remove the bobbin. (Refer to
page 38.)
2 Slide the paper under the tension-adjusting
spring to remove any dust.
Use a corner of the paper to remove any dust
from around the hole.
1 Tension-adjusting spring
2 Hole
3 Paper