Brother 884-T11 Operation Manual page 301

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
The installed embroidery frame is
too small.
Check which embroidery frames
can be used, and then install a
larger embroidery frame. (Refer to
page 49.)
The patterns you are editing take
up too much memory, or you are
editing too many patterns for the
memory.
The needle bar case could not be
moved to its initial position.
Touch
reset the needle bar case.
The upper thread broke, the
thread came out of the thread
tension disc or a thread guide, or
the machine is not threaded
correctly.
Check that the thread passes under
the upper and middle thread
guides, and correctly thread the
upper thread. (Refer to page 56.) If
the thread is not broken, clean the
thread guides and the tension unit.
(Refer to page 285.)
Sewing cannot begin from the
specified starting position.
Change the starting position or
rehoop the fabric and change the
embroidering position. (Refer to 94,
135.)
The needle bar case has stopped at
an incorrect position.
to automatically Touch
reset the needle bar case.
The bobbin thread broke or ran
out.
Check that there is thread on the
bobbin and that approximately 50
mm (2 inches) of thread has been
pulled out, and then re-install the
bobbin. (Refer to page 38.)
The needle has stopped at an
incorrect position.
Turn the handwheel so that the
mark on the handwheel is at the
top.
The needle bar case motor has
locked up.
to automatically Touch
reset the needle bar case.
to automatically
Troubleshooting 299
7