Brother 884-T11 Operation Manual page 108

OTHER BASIC PROCEDURES — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Note
● The built-in camera may not be able to
detect the embroidery positioning sticker if
the four corners of the sticker are not
firmly affixed to the fabric. Use tape to
firmly affix the sticker to the fabric.
● When using the optional cap frame or
cylinder frame, attach the embroidery
positioning sticker so that the two circles
of the positioning mark fit within one of
the embroidering areas.
● If the embroidery positioning sticker has
been affixed over two areas, the sticker
will be detected no matter which of the
two areas is selected.
4 Touch .
5 When the following message appears, touch
.
The built-in camera automatically detects
the embroidery positioning sticker, and
then the embroidery frame is moved so
that the center of the embroidery pattern is
aligned with the center of the large circle
in the embroidery positioning sticker.
106
6 When the machine's built-in camera has
finished detecting the location of the
embroidery positioning sticker, the following
message appears.
Memo
● You can touch
embroidery position is correctly aligned
before removing the embroidery
positioning sticker.
• Touch
which would make it easier to find the
position.
• Touch
• Touch
previous screen.
7 Remove the embroidery positioning sticker
from the fabric.
to confirm the
to display the grid lines
for the closer image.
again to return to the