Controls System Maintenance; Adjusting The Control-Handle Position - Toro Z Master Revolution Series Operator's Manual

4. In the S menu, scroll down to M
ERVICE
R and press the
ANGE
Figure 69
5. Adjust the maximum speed range as desired.
Figure 70
Note:
The number indicates the maximum
speed setting (2 through 7) that the operator can
select on the main information screen as shown.
Figure 71
6. Press the button to save the new value.
S
AX PEED
button.
g425331
g425330
g425332
Controls System
Maintenance
Adjusting the
Control-Handle Position
Adjusting the Height
You can adjust the motion control levers higher or
lower for maximum comfort.
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
position.
2. Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the hardware holding the motion-control
lever to the control-arm shaft.
1. Bolt (2)
4. Move the control lever to the next set of holes.
Secure the lever with the hardware.
5. Repeat the adjustment for the opposite control
lever.
44
ARK
Figure 72
2. Control-arm shaft
g400371