Before Operation; Before Operation Safety; Performing Daily Maintenance; Using The Rollover-Protection System (Rops) - Toro Z Master Revolution Series Operator's Manual

Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.

Before Operation

Before Operation Safety

•
Do not operate the machine unless all safety
switches and other devices are in place and
working properly.
•
Before leaving the operator's position for any
reason, do the following:
– Park the machine on a level surface.
– Disengage the drives and the power take-off.
– Engage the parking brake.
– Shut off the machine and remove the key.
– Wait for all moving parts to stop.
•
Before mowing, always inspect the machine to
ensure that the blades, blade bolts, and cutting
assemblies are in good working condition.
•
This product generates an electromagnetic field.
If you wear an implantable electronic medical
device, consult your health care professional
before using this product.
•
Use only accessories and attachments approved
by Toro.
•
Do not carry passengers on the machine and
keep bystanders and pets away from the machine
during operation.
•
This machine produces a sound power level that
exceeds 85 dBA at the operator's ear, which can
cause hearing loss through extended periods
of exposure. Wear hearing protection when
operating this machine.
•
Before operating the machine, ensure that
the operator presence controls and either the
discharge deflector or the entire grass collection
system are in place and working properly.
Otherwise, do not operate the machine.
•
When you shut off the machine, the blades should
stop. If not, stop using the machine immediately
and contact an Authorized Service Dealer.
•
Shut off the machine and attachment(s) if anyone
enters the area.
Performing Daily
Maintenance
Before starting the machine each day, perform the
Each Use/Daily procedures listed in
(page 37).
Using the
Rollover-Protection System
(ROPS)
WARNING
To avoid injury or death from rollover, keep
the roll bar in the fully raised, locked position
and use the seat belt.
Ensure that the seat is secured to the
machine.
WARNING
There is no rollover protection when the roll
bar is in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar
is in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance
permits.
• Check carefully for overhead clearances
(i.e., branches, doorways, electrical wires)
before driving under any objects and do
not contact them.
19
Maintenance