Toro Z Master Revolution Series Operator's Manual page 17

Settings
Menu Item Description
Controls the language used on the
L
ANGUAGE
InfoCenter.
Controls the brightness of the LCD
B
ACKLIGHT
display.
Controls the contrast of the LCD
C
ONTRAST
display.
Allows you to access protected menus
P M
ROTECTED ENUS
by inputting a passcode.
About
Menu Item Description
Displays the model number of the
M
ODEL
machine.
Displays the serial number of the
SN
machine.
Displays the software part number
M C
AIN ONTROLLER
and revision of the main controller.
D C Displays the software part number
ISPLAY ONTROLLER
and revision of the display controller.
Displays the software part number and
TU M
OTORS
revision of the traction unit motors.
Displays the software part number
CU M
OTORS
and revision of the cutting unit motors.
Displays the software part number
B P
ATTERY ACKS
and revision of the battery packs.
Accessing Protected Menus
Note:
The factory default PIN code for your machine
is 1234.
If you changed the PIN code and forgot the code,
contact your Authorized Service Dealer for assistance.
Note:
The InfoCenter displays only 2 items at a time;
however, the following figures show the full menus
for context.
1. In the M
AIN MENU
press the button.
, scroll down to S
ETTINGS
Figure 14
2. In the S
and press the
MENUS
3. To enter the PIN code, use the 2 center buttons
to input each digit, and press the
move on to the next digit. Repeat this step until
the last digit is entered and press the
again.
4. Press the
Note:
If the InfoCenter accepts the PIN code
and the protected menu is unlocked, the word
"PIN" displays in the upper right corner of the
screen.
and
g375695
17
menu, scroll down to P
ETTINGS
button.
Figure 15
Figure 16
button to confirm the PIN code.
Figure 17
ROTECTED
g375693
button to
button
g375692
g377941