Moving A Non-Functioning Machine - Toro Z Master Revolution Series Operator's Manual

Moving a Non-Functioning
Machine
Important:
Do not tow the machine without first
disengaging the transmission, otherwise you
could damage motor components.
CAUTION
The machine does not have brakes when
the transmission is disengaged. It will roll
uncontrolled, possibly causing injury.
Use caution when towing the machine and
engage the transmission after moving it.
1. Disengage the PTO and move the motion-control
levers outward to the P
2. Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the cap from the motor.
Figure 46
1. Motor cap
position.
ARK
g398424
4. Disengage the transmission.
A. Insert a ratchet with a 3/8 inch drive into the
square hole in the motor hub.
B. Rotate it counterclockwise until it stops
(approximately 4 full rotations) to disengage
the transmission.
C. Torque to 41 to 68 N∙m (30 to 50 ft-lb).
Note:
The wheel will spin freely.
5. Repeat for the other motor.
6. Move the machine to the desired location.
Important:
Do not move the machine faster
than 8 km/h (5 mph).
7. Immediately after moving the machine, engage
the transmission for operation.
A. Insert a ratchet with a 3/8 inch drive into the
square hole in the motor hub.
B. Rotate it clockwise until it stops
(approximately 4 full rotations).
C. Torque to 41 to 68 N∙m (30 to 50 ft-lb).
32
Figure 47
Figure 48
g398425
g398426