Connecting Input Power - Hobart H100S2-10 Owner's Manual

.
A complete Parts List is available at www.HobartWelders.com

5-7. Connecting Input Power

!
Do not move or operate unit
where it could tip.
!
Installation must meet all National
and Local Codes − have only
qualified persons make
installation.
!
Special installation
required where gasoline or volatile
liquids are present − see NEC
Article 511 or CEC Section 20.
5-8. Selecting Extension Cord (Use Shortest Cord Possible)
Single Phase AC
Input Voltage
115
*Conductor size is based on maximum 3% voltage drop
OM-258 267 Page 16
A 115 volts AC, 20 ampere individual circuit
protected by time-delay fuses or circuit
breaker is required.
this
may be
10 (5.3)
Maximum Allowable Cord Length in ft (m)
100 (30.5)
1
2
2
Conductor Size − AWG (mm )*
2
Plug From Unit
Receptacle − NEMA Type 5−15R
(Customer Supplied)
Input6 2011−03 258 641-A
12 (3.3)
50 (15.0)
1