Connecting 120 Volt Input Power (Stickmate 160I Only) - Hobart Stickmate 160i Owner's Manual

5-9. Connecting 120 Volt Input Power (Stickmate 160i Only)

Notes
.
A complete Parts List is available at www.HobartWelders.com
!
!
.
For 120 volts AC input power, a 15 or 20
ampere individual branch circuit protected
by time-delay fuses or circuit breaker is
required.
1
1
For additional multi−voltage plug (MVP)
connections, see Section 5-6.
2
Work like a Pro!
Installation must meet
National and Local Codes − have
only qualified persons make this
installation.
Special installation may
required where gasoline or volatile
liquids are present − see NEC Ar-
ticle 511 or CEC Section 20.
The circuitry in this unit automatically
links the power source to the primary
voltage being applied, either 120 or
240 VAC.
Multi-Voltage Plug And Power Cord
Connector (NEMA Type 5−15P Plug
Shown)
Receptacle − NEMA Type 5−15R
(Customer Supplied)
2
Ref. Input6 2011−03 Ref. 279230
Pros weld and cut
safely. Read the
safety rules at
the beginning
of this manual.
OM-278400 Page 19
all
be