Section 6 − Operation; Controls - Hobart H100S2-10 Owner's Manual

.
A complete Parts List is available at www.HobartWelders.com

6-1. Controls

1 Wire Speed Control
Use control to select a wire feed speed. As
Voltage switch setting increases, wire
speed range also increases (see weld
setting label in welding power source or
Section 6-2).
2 Power Switch
3 Voltage Switch
The higher the selected number, the
OM-258 267 Page 20
SECTION 6 − OPERATION
1
5
thicker the material that can be welded
(see weld setting label in welding power
source or Section 6-2). Do not switch under
load.
.
Switch must "click" into detent
position for weld output.
4 Over Temperature Light
Light illuminates if main transformer over-
heats.
2
5 Gun Trigger Switch
Pressing gun trigger energizes wire feed
motor and gas valve for shielding gas flow.
Gun trigger switch must be pressed
(closed) and held to weld. Releasing the
gun trigger switch shuts off the weld output,
wire feed, and gas flow (where applicable).
3
4
258 346-A