For EDACS and Motorola (above 406 MHz
range), the scanner monitors the control
channel between each transmission to
identify talk groups. For some Motorola
(under 512 MHz range) and LTR systems,
the scanner uses the subaudible data
sent with each transmission to identify
talk groups.
Trunking Delay
You.can.set.a.Talk.Group.ID.delay.separately.
from.the.channel.delay..When.active,.the.
scanner.checks.the.Talk.Group.ID.for.the.delay.
time.when.a.transmission.ends.
To set a Talk Group ID delay:
1.. Press.FUNC.then../DELAY.while.you.are.
programming.the.Trunk.Group.ID.."ENTER.
key.saves..2.0.seconds".appears.
2.. Use..or..to.set.ID.Delay:.None,.0.5,.1.0,.
1.5,.2.0,.2.5,.3.0,.3.5,.or.4.0.seconds.
3.. Press.ENT.
Locking Out Talk Group IDs
You.can.only.lock.out.Talk.Group.IDs.when.the.
scanner.is.in.the.Closed.mode.
To lock out Talk Group IDs:
1.. Press.PGM.then.TRUNK.
2.. Press.FUNC,..or..to.move.to.the.desired.
bank.
3.. Press..or..to.select.the.ID.
4.. Press.L/OUT.to.lock.out.the.ID.."lo".changes.
to."LO."
5.. To.remove.the.lockout.from.a.trunking.ID,.
manually.sele
L/OUT..LO.ch
You cannot
group at th
To review locked
1.. Press.PGM.th
2.. Press.FUNC..
out.ID.appear
no.locked-ou
tone.
3.. Press..or.
4.. Press.PGM.to
Turning Off
To turn off a sub-
1.. Press.TRUNK
desired.sub-b
2.. Press.FUNC.t
if.it.is.off.or.o
To turn off a sub-
1.. When.the.sca
press.FUNC.
2.. Press.TRUNK
sub-bank.is.tu
bank.number
3.. Press.FUNC.a
bank.you.des
example.to.tu
FUNC..Then.p
This functio
receiving c