Quick Start; Power-Up The Dlplcrc910Evm; Power-Down The Dlplcrc910Evm - Texas Instruments DLP LightCrafter DLPC910 User Manual

www.ti.com

4 Quick Start

This chapter offers a quick start guide to power-up the DLPLCRC910EVM and run the GUI control software.

4.1 Power-up the DLPLCRC910EVM

The DLPLCRC910EVM is ready to use after assembling with a supported DMD EVM and a front end board such
as the AMD Xilinx VC-707 EVM. Steps 1 through 6 show how to power, display an image, and connect the EVM
to a PC.
1. Before connecting the AMD Xilinx VC-707 board program the configuration PROM per the instructions in
AMD Xilinx VC-707 Configuration PROM
2. Connect a 12-V DC power supply to the power supply connector J15 in
3. LED — D4 illuminates if power is present at J15.
4. Power on the AMD Xilinx VC-707 board.
Allow sufficient time for the VC-707 board to configure (10 seconds is suggested).
5. Turn on SW3 [DMD Park (PWR_FLOAT)].
6. Turn on SW4 [Power Enable].
7. LED — D7 illuminates indicating that the PROM has configured the DLPC910.
8. LED — D2 briefly illuminates indicating calibration is in progress and goes out when complete.
9. LED — D1 flashes (heartbeat) to indicating that the DLPC910 is running.
A DMD EVM board and a properly configured AMD Xilinx VC-707 board must be present for the
DLPC910 to initialize.
10. Connect a USB cable from a PC to connector J1 on the DLPLCRC910EVM, as seen in
time the cable is connected on a PC, the DLPLCRC910EVM enumerates. The required drivers are installed
as part of the DLPLCRC910EVM GUI installation.
11. The DLPLCRC910EVM can be controlled with the GUI software available for download from the
DLPLCRC910EVM Tool

4.2 Power-down the DLPLCRC910EVM

To shut down the DLPLCRC910EVM follow steps 1 through 4:
1. Recommended: In the DLPC910 GUI issue a
Issuing a DMD Park (PWR_FLOAT) via software is not required but is good practice.
2. Turn off SW3 [DMD Park]
3. Turn off SW4 [Power Enable]
4. Power off the AMD Xilinx VC-707 board
DLPU124 – JUNE 2023
Submit Document Feedback
Programming.
Folder.
DMD Park
Copyright © 2023 Texas Instruments Incorporated
Figure
Note
Note
(PWR_FLOAT) command
Note
DLP® LightCrafter™ DLPC910 Evaluation Module (EVM)
Quick Start
3-3.
Figure 3-3. The first
21