Texas Instruments DLP LightCrafter DLPC910 User Manual page 11

www.ti.com
Table 3-1. DLPLCRC910EVM Connector Reference (continued)
Connector
EVM Function
Reference
J11 DCLKIN Speed Selection Pin 0
J12 VSP Enable (no longer used)
J13 DLPC910 Test Points 0 - 7
+12 VDC 6-Pin Power Connector
J14
(Alternate)
J15 +12 VDC Power input
J16 REV_SEL_0
J17 JTAG Connector
J18 Flash Configuration Connector
+12 VDC external Fan
J19, J20, J21
Connectors
J22 Apps FPGA Reset Jumper
J500 Apps FPGA FMC connector 1
J501 Apps FPGA FMC connector 2
DLPU124 – JUNE 2023
Submit Document Feedback
DLP LightCrafter DLPC910 EVM (DLPLCRC910EVM) Overview
SPEED_SEL_0 used in conjunction with J7 (SPEED_SEL_1) to select 400 or 480
MHz operation. Routed to Apps FPGA.
Configurations:
• 400 MHz: J7 and J11 jumpered - DLP6500FLQ, DLP9000X, or DLP9000XUV
(default)
• 480 MHz: J7 jumpered and J11 not jumpered - DLP9000X and DLP9000XUV only
The DLPLCR65FLQEVM does not run at 480 MHz.
Although the DLP9000X and DLP9000XUV run at 400 MHz, only 480
MHz operation has been fully validated.
This jumper is no longer used.
DLPC910 connected test points:
• GND: Pin 1
• DLPC_TSTPT0: Pin 2
• DLPC_TSTPT1: Pin 3
• DLPC_TSTPT2: Pin 4
• DLPC_TSTPT3: Pin 5
• DLPC_TSTPT4: Pin 6
• DLPC_TSTPT5: Pin 7
• DLPC_TSTPT6: Pin 8
• DLPC_TSTPT7: Pin 9
• GND: Pin 10
Reserved for TI internal testing and debug.
EVM power alternate input. [Pin 1,2,3 = GND, Pin 4,5,6 = +12 VDC, ] See
EVM power input. [Pin 1 = +12 VDC, Pin 2,3 = GND] See
DLPR910 Configuration Prom Revision Selection Jumper. REV_SEL_1 is held low.
• Not jumpered = 0 (default)
• Jumpered = 1 - Not Used
JTAG header for connecting a JTAG programmer to the DLPR910.
SPI Flash programming connector.
2-pin +12 VDC fan connectors [Pin 1 = GND, Pin 2 = +12 VDC]
Jumper 22 prevents SW1 from pulling the Apps FPGA on the attached AMD Xilinx
VC-707 EVM into reset.
• Not jumpered = Allows SW1 to pull the Apps FPGA into reset (default)
• Jumpered = Prevent SW1 from pulling Apps FPGA into reset
DLPC910 to Apps FPGA and USB parallel interface to the Apps FPGA 400 pin FMC
connector.
DLPC910 to the Apps FPGA 400 pin FMC connector.
Copyright © 2023 Texas Instruments Incorporated
Description or Use
Note
Section
DLP® LightCrafter™ DLPC910 Evaluation Module (EVM)
Section 7.1.
7.1.
11