Texas Instruments DLP LightCrafter DLPC910 User Manual page 10

DLP LightCrafter DLPC910 EVM (DLPLCRC910EVM) Overview
Table 3-1. DLPLCRC910EVM Connector Reference (continued)
Connector
EVM Function
Reference
J6 USB GPIO B0 - B7
J7 DCLKIN Speed Selection Pin 1
DMD EVM Board HPC FMC
J8
Connector
J9 DLPC910 Test Points 8 - 15
2
DLPC910 I C Address Selector
J10
Jumper
10 DLP® LightCrafter™ DLPC910 Evaluation Module (EVM)
USB GPIO Header:
• GND: Pin 1
• USB GPIO B7: Pin 2
• USB GPIO B6: Pin 3
• USB GPIO B5: Pin 4
• USB GPIO B4: Pin 5
• USB GPIO B3: Pin 6
• USB GPIO B2: Pin 7
• USB GPIO B1: Pin 8
• USB GPIO B0: Pin 9
• GND: Pin 10
These pins are available for customer definition or future use.
SPEED_SEL_1 used in conjunction with J11 (SPEED_SEL_0) to select 400 or 480
MHz operation. Routed to Apps FPGA.
Configurations:
• 400 MHz: J7 and J11 jumpered - DLP6500FLQ, DLP9000X, or DLP9000XUV
(default)
• 480 MHz: J7 jumpered and J11 not jumpered - DLP9000X and DLP9000XUV only
The DLPLCR65FLQEVM does NOT run at 480 MHz.
Used to connect a DLPLCR65FLQEVM, DLPLCR90XEVM, or DLPLCR90XUVEVM.
DLPC910 connected test points:
• GND: Pin 1
• DLPC_TSTPT8: Pin 2
• DLPC_TSTPT9: Pin 3
• DLPC_TSTPT10: Pin 4
• DLPC_TSTPT11: Pin 5
• DLPC_TSTPT12: Pin 6
• DLPC_TSTPT13: Pin 7
• DLPC_TSTPT14: Pin 8
• DLPC_TSTPT15: Pin 9
• GND: Pin 10
Reserved for TI internal testing and debug.
2
Selects the DLPC910 I C Address:
• 0x36: Not jumpered (default)
• 0x34: Jumpered
If installed, then use the DLPC910 Status/Control
page to change the I
Copyright © 2023 Texas Instruments Incorporated
Description or Use
Note
Note
Registers Settings
2
C address to operate correctly.
www.ti.com
DLPU124 – JUNE 2023
Submit Document Feedback