Quick Start; Usb Connection; Wall Power Connection - Texas Instruments MSC1200EVM User Manual

2.3 Quick Start

Once the MSC1200EVM has been unpacked from its shipping container, and
you have verified that the board is configured as shown in Table 1, it can be
powered on and tested.
There are two options for supplying power to the EVM: via a USB connection
through the host computer, or from an external wall mount power adapter.
2.3.1

USB Connection

Connect the board to the host PC using the supplied USB serial cable. When
the board is properly powered on, the green power good LED near the power
USB connector will glow brightly.
2.3.2

Wall Power Connection

Connect the board to the host PC using the supplied 9-pin serial cable. Then
power on the board by plugging the wall power adapter into a suitable AC pow-
er source and plugging the barrel plug into the barrel jack on the
MSC1200EVM. (You do not have to connect the serial cable first; it is also
acceptable to apply power to the board first.) When the board is properly pow-
ered on, the two green power good indicator lamps near the power connectors
will glow brightly.
Place the CD-ROM into the PC's CD−ROM drive. You should then see the
installation screen shown in Figure 2−1.
Quick Start
Getting Started
2-3