Toro Workman 07369 Operator's Manual page 40

1. Note the clearance between the fill device and the oil-fill
neck.
8. Install the filler cap onto the filler neck.
9. Firmly install the dipstick.
Changing the Engine Oil and Filter
Service Interval: After the first 50 hours
Every 100 hours
1. Raise the bed and place the safety support on
the extended lift cylinder to hold up the bed.
2. Align a large drain pan under the oil-drain plug
(Figure 35).
3. Remove the drain plug and let the oil flow into a
drain pan (Figure
1. Drain plug
4. When the oil stops draining, install the drain
plug.
Figure 34
35).
Figure 35
2. Engine-oil filter
5. Remove the oil filter from the filter adapter
(Figure 35).
6. Wipe clean the sealing base of the of the filter
adapter.
7. Apply a light coat of clean oil to the seal of the
new filter.
8. Install the filter until the gasket contacts the
sealing base of the filter adapter, then tighten the
filter clockwise and additional 1/2 to 2/3 of a turn.
Note:
Do not overtighten the engine-oil filter.
9. Add the specified oil to the crankcase of the
engine.
g002373
g009272
40