Installing The Roll Bar; Burnishing The Brakes - Toro Workman 07369 Operator's Manual

2

Installing the Roll Bar

Parts needed for this procedure:
1 Roll bar
6 Flange-head bolt (1/2 x 1-1/4 inches)
Procedure
1. Apply medium-grade (service-removable)
thread-locking compound to the threads of the 6
flange-head bolts (1/2 x 1-1/4 inches).
2. Align each side of the roll bar with the mounting
holes on each side of the machine frame
3).
1. Roll bar mounting bracket
3. Secure the roll bar mounting bracket to the
machine frame using 3 flange-head bolts (1/2 x
1-1/4 inches) on each side
4. Torque the flange-head bolts (1/2 x 1-1/4 inches)
to 115 N∙m (85 ft-lb).
Figure 3
2. Flange-head bolt (1/2 x
1-1/4 inches)
(Figure 3).
3

Burnishing the Brakes

No Parts Required
Procedure
To ensure optimum performance of the brake system,
burnish the brakes before use.
1. Bring the machine up to full speed, apply the
brakes to rapidly stop the machine without
locking up the tires.
2. Repeat this procedure 10 times, waiting 1 minute
between stops, to avoid overheating the brakes.
(Figure
Important:
if the machine is loaded with 454 kg (1,000
lb).
g009812
12
This procedure is most effective