Xerox AltaLink C81 Series User Manual page 303

• Allowing the output tray to fill with more than a few transparencies.
C C l l e e a a r r i i n n g g P P a a p p e e r r J J a a m m s s
To clear jams, watch the video and follow the instructions on the control panel. To resolve the error
that appears on the control panel, remove all paper from the areas shown. If the error does not clear,
check the jam areas again to ensure that all paper has been removed. Ensure that all levers, covers,
and doors have been closed correctly.
To avoid damage, always remove jammed paper carefully without tearing it. Try to remove the paper
in the same direction it normally moves through the printer. Even a small piece of paper left in the
printer can cause a jam. Do not reload paper that has jammed.
Note: Do not touch the printed side of the paper when removing it. The printed side of
jammed pages could smudge, and the toner could stick to your hands. Avoid spilling any toner
inside the printer.
If you accidentally get toner on your clothes, lightly dust them off as best as you
WARNING:
can. If some toner remains on your clothes, use cool water, not hot, to rinse off the toner. If
toner gets on your skin, wash it off with cool water and a mild soap. If you get toner in your
eyes, wash it out immediately with cool water and consult a doctor.
D D u u p p l l e e x x A A u u t t o o m m a a t t i i c c D D o o c c u u m m e e n n t t F F e e e e d d e e r r J J a a m m s s
If a jam occurs in the duplex automatic document feeder areas, a message appears to indicate the
areas that require clearing. To clear the jam, clear the areas indicated, then reorder and reload your
original documents in the document feeder input tray. The device continues scanning the job from
the point the job stopped, only scanning the original documents remaining.
If your device has the multi-feed sensor installed and enabled, the device can detect if a multi-feed of
original documents is going through the duplex automatic document feeder. If a multi-feed condition
occurs, the device stops scanning and a message appears at the control panel. The message indicates
a jam in the duplex automatic document feeder. The user can reload the original documents and
continue the job with or without multi-feed detection enabled for that job, or cancel the job.
For detailed instructions on how to configure the Document Feeder Multi-feed Detection setting, refer
to the System Administrator Guide at www.xerox.com/office/ALC81XXdocs.
If the original documents continue to jam, then for more information about the causes of document
feeder jams and potential solutions, refer to
Clearing Jams in the Document Feeder
Torn, wrinkled, or folded original documents can cause jams and damage the printer.
Caution:
To copy torn, wrinkled, or folded original documents, use the document glass.
Jams in the Document
Xerox AltaLink C81XX Series Color Multifunction Printer
® ®
Troubleshooting
Feeder.
User Guide
303