Table of Contents
Advertisement
7.5 Adjusting detergent and rinse aid dispensing (only available on certain models)
Rinse aid – Grams/liter dosage (depends on model)- The display reads "ri"
NOTE: Do not exceed the amount indicated by the manufacturer, as shown on the package.
An excessive amount may cause foaming.
Detergent - Grams/liter dosage (depends on model) - The display reads "dE"
NOTE: Do not exceed the amount indicated by the manufacturer, as shown on the package.
An excessive amount may cause foaming.
7.6 Starting the peristaltic pump in manual mode-rapid filling of detergent and rinse aid
circuit
Energized dishwasher and full tank: press for 5 seconds buttons P2
The peristaltic pumps work until P1 or P2 are pressed again; during the procedure the indicator lights stay
on and the display shows "rd". The rinse aid circuit is filled in 7 minutes, the detergent circuit is filled in 2
minutes.
Since the pumps work at the same time, only the rinse aid (blue tube in the rinse aid jerrycan) must be
withdrawn for 5 minutes, then the detergent (red tube in the detergent jerrycan) is withdrawn too for the
last two minutes.
Every time
is pressed,
the value increases of 0,1 g/l
up to a max. of 2 g/l.
Default: 0,4 g/l.
Every time
is pressed,
the value increases of 0,2 g/l
up to a max. of 10 g/l.
Default: 1,4 g/l.
17
+P3
simultaneously.
Advertisement
Table of Contents
