7.3 Parameter programming procedure (setup)
To modify the parameters, proceed as follows starting with the appliance in "OF" status with the door
open.
1) Switch the appliance using the On/OF button
2) Press and hold the button
3) Press the pump-out button
4) Modify the parameter by pressing button P1
5) During setup operations, the description and value of the parameter alternate on the display.
6) Select the other parameters for modification in the same way and proceed as described above
7) To exit the setup menu press and hold
at least 3 minutes without pressing any key; in this way the machine automatically exits the setup menu.
7.4 Modifiable parameters
This table lists the model choice or programme and temperature option parameters.
Display
Settings available
°b
From 85° to 71°
°t
From 62° to 52°
ri
0 – 2 gr/lt (in steps of 0,1)
dE
0-10 gr/lt (0-10 in steps of 0,2)
St
On - OF
HA
H0 – H6
Er
On-OF
CL
On-OF
TS
On - OF
Fi
FS-EC
until the display shows "- -" , release and press again.
to scroll through the parameters for modification
until the display shows "OFF", press P2
Boiler temperature
Tank temperature
Rinse aid batching
Detergent batching
Auto-start:
washing programme starts when door is closed
On enabled OF disabled
Water hardness setting
Prolonged rinse at the end of the washing cycle (+8").
On enabled OF disabled
Clean water cycle. On enabled OF disabled
Thermostop On enabled OF disabled
Starting the machine in FAST or ECO mode
(models without rinsing pump only)
16
Description
or P3
or wait