User Guide
2.17.2
User Guide
1.800.561.8187
6. Insert and tighten the two screws. Do not over tighten the screws. Use 0.5Nm
maximum torque load.
Calibration
Calibration is not supported on the AMS Trex Device Communicator. Voltage, current,
signal, and noise measurements made by the Trex unit are intended for troubleshooting
purposes. NIST standards are not applicable to the AMS Trex Device Communicator.
www.
AMS Trex Device Communicator overview
information@itm.com
.com
September 2021
51