Emerson AMS Trex Device Communicator User Manual page 157

User Guide
User Guide
1.800.561.8187
Default status labels for the noise measurement
Default status labels for the signal measurement
If the fieldbus signal measurement has a BAD or CHECK status, an additional status note is
listed on the Fieldbus Diagnostics Overview screen.
Fieldbus signal status note
Within the range for all nodes
Signal low/high on all devices
Signal low/high on most devices
www.
Fieldbus Diagnostics application
Description
All devices on the fieldbus segment have a GOOD fieldbus
signal.
All devices on the fieldbus segment have signal
measurements that are higher than the set maximum
value or lower than the set minimum value.
More than half of the devices on the fieldbus segment
have signal measurements that are higher than the set
maximum value or lower than the set minimum value.
information@itm.com
.com
September 2021
157