KTM 85 SX 2019 Owner's Manual page 77

–
5
Remove pin
–
Take off retainer spring
–
Clean the brake caliper.
–
Position new brake linings.
Info
Always change the brake linings in pairs.
–
Position retaining spring
S01169-10
–
5
Mount pin
Info
To make it easier to mount the pin, push the retainer
spring down.
Make sure the retaining spring is seated correctly.
–
Position the brake caliper.
–
Mount screws
Guideline
Screw, front
brake caliper
–
5
Tighten pin
Guideline
Pin, front brake
S01168-10
–
Mount cotter pins
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point. Fix the hand brake lever in the activated position.
The brake caliper straightens.
–
Tighten screws
Guideline
Screw, front
brake caliper
–
Remove the locking piece of the hand brake lever.
–
Add brake fluid to level
Guideline
A
Level (brake fluid level
below reservoir rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Position cover
–
Mount and tighten screws
V00865-10
Info
Clean up overflowed or spilled brake fluid immediately
with water.
.
7
and remove the brake linings.
7
.
but do not tighten yet.
6
with the spacers but do not tighten yet.
M8 25 Nm (18.4 lbf ft)
.
M6 8 Nm (5.9 lbf ft)
4
.
6
.
M8 25 Nm (18.4 lbf ft)
A
.
5 mm (0.2 in)
p. 119)
2 3
with membrane .
1
.
BRAKE SYSTEM 12
Loctite ® 243™
Loctite ® 243™
75