Table of Contents
Advertisement
15 TUNING THE ENGINE
15.7
15.8
Switching the ignition timing map from Performance to Soft
–
Switching the ignition timing map from Soft to Performance
–
15.9
15.10
100
Plug-in connector of ignition timing map adjustment
T01480-10
Changing the ignition timing map
Disconnect plug-in connector
Soft – Better rideability
Join plug-in connector
1
of the ignition timing map adjustment. (Figure T01480-10
Performance – Higher performance
Checking the basic position of the shift lever
Info
When driving, the shift lever must not touch the driver's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
400692-10
Adjusting the basic position of the shift lever
401950-12
Plug-in connector
1
located on the frame under the fuel tank.
Possible states
Soft – The plug-in connector of the ignition timing map
•
adjustment is disconnected to achieve better rideability.
Performance – The plug-in connector of the ignition timing
•
map adjustment is joined to achieve higher performance.
1
of the ignition timing map adjustment. (Figure T01480-10
–
Sit on the vehicle in the riding position and determine
distance
A
between the upper edge of your boot and the shift
lever.
Distance between shift lever
and upper edge of boot
»
If the distance does not meet specifications:
–
Set the basic position of the shift lever.
–
1
Remove screw
lever
2
.
of the ignition timing map adjustment is
p. 100)
10 ... 20 mm (0.39 ...
0.79 in)
with the washers and take off shift
p. 100)
(
p. 100)
Advertisement
Table of Contents
