Reading Indications From The Pc With Digsi 5 - Siemens SIPROTEC 5 V9.30 Manual

Operation in the Operating State
8.4 Indications

Reading Indications from the PC with DIGSI 5

8.4.3
Procedure
Menu Path (Project)
Project → Device → Process data → Log →
Online access → Device → Device information →
Logs tab →
Online access → Device → Test suite → Communica-
tion module → Hardware
To read the indications with DIGSI 5 your PC must be connected via the USB user interface of the on-site
operation panel or via an Ethernet interface of the device. You can establish a direct connection to your PC
via the Ethernet interfaces. It is also possible to access all connected SIPROTEC 5 devices via a data network
from your DIGSI 5 PC.
You reach the desired logs of the SIPROTEC 5 device using the project-tree window. If you have not
²
created the device within a project, you can also do this via the Online access menu item.
After selecting the desired log, you are shown the last state of the log loaded from the device. To update, it is
necessary to synchronize with the log in the device.
Synchronize the log. For this purpose, click the appropriate button in the headline of the log (see the
²
ground-fault indications example in
[sc_grflmd, 1, en_US]
Figure 8-7
1 There may potentially be several communication modules to select from
164
1
Figure 8-7
DIGSI 5 Display of an Indication List (Example of Ground-Fault Log)
Log
Operational log
Fault log
Switch. device log
Ground-fault log
Setting-history log
User log 1
User log 2
Motor-starting log
Com supervision log
Device-diagnosis log
Security indications
Communication log
a)).
C53000-G5040-C003-J, Edition 07.2022
SIPROTEC 5, Operation, Manual