Removing the Dispenser Pad Assembly
1. Complete the steps
1-3
Interface.
2. Remove drip tray and then remove four (4) screws holding
dispenser housing.
from section Removing the User
JennAir® and KitchenAid® 36", 42", and 48" Built-In Side by Side Refrigerators
COMPONENT ACCESS (CONT.)
3. Remove door skin by removing three (3) phillips screws on
top, six (6) phillips screws on the side and two (2) phillips
screws on the bottom.
Figure - Removing the Top Screws
Figure - Removing the Side Screws
Figure 3. Removing the Bottom Screws
4-17
n