Jenn-Air KitchenAid KBSD708M S00 Series Technical Manual page 33

Removing the Ice Maker Assembly
(Dispensing Units Only)
1. Remove four (4) 1/4" hex head screws on bracket. Three (3)
are on the side wall and one (1) on ceiling wall.
2. Rotate Ice maker bottom towards the front of the refrigerator
to get metal bracket out of the ceiling.
3. Disconnect the electrical connector and then remove the ice
maker.
JennAir® and KitchenAid® 36", 42", and 48" Built-In Side by Side Refrigerators
COMPONENT ACCESS (CONT.)
Removing the Fill Tube Heater
(Non-dispensing Units Only)
1. Complete the steps 1-4
Assembly (Non-dispensing Units Only).
2. Disconnect the electrical connector and then remvoe the
heater.
Removing the Fill Tube (Non-dispensing
Units Only)
1. Complete the steps 1-4
Assembly (Non-dispensing Units Only).
2. Complete the steps 1-3 from section Removing the Fill Tube
Heater (Non-dispensing Units Only).
3. Complete the steps 1-3
Water Inlet and Isolation Valves.
4. Remove the water line from the ice maker water inlet valve
by removing the lock ring from the John Guest fitting first.
from section Removing the Ice Maker
from section Removing the Ice Maker
from section Accessing the Ice Maker
4-13
n