Jenn-Air KitchenAid KBSD708M S00 Series Technical Manual page 35

9. Locate cover over fill tube in front of compressor and remove
three (3) 1/4" hex head screws and then remove the cover.
A. Cover
B. Fill Tube
10. Inside the FC, pull on fill tube to remove fill tube and water
line.
JennAir® and KitchenAid® 36", 42", and 48" Built-In Side by Side Refrigerators
COMPONENT ACCESS (CONT.)
Removing the Emitter Cover and Circuit
Board (Dispensing Units Only)
1. Locate the Emitter on the outer wall and remove three (3)
phillips head screws to remove cover and board.
2. After disconnecting wire harness, remove two (2) phillips
head screws to remove the emitter circuit board.
4-15
n